Product Description:
MD-FS210 series heat flow switch adopts heat diffusion principle. There are two temperature sensors in the probe: one is used as a reference sensor to measure the temperature of the medium, and the other is used as a measurement sensor after being heated. The temperature difference between the two sensors is used as the basis for measuring the flow velocity. When the flow velocity of the medium increases, the temperature difference decreases, and vice versa. The temperature difference value is converted into standard electrical signal and displayed after processing. The FS210 series are all designed with all-metal shell, with 8-bit LED showing flow trend and switching status. One product is suitable for various pipe diameters. It can be set by keyboard or computer. No moving parts, maintenance-free, can be used in a variety of media.
- wide range - through the button switch point or defined range More parameters can also be set by handheld Settings or computer -8 LEDS show flow trend and on/off status -PNP/NPN/ relay electrical output optional - Easy to operate inductive button setting - Protection level IP67 - Small structure diameter 36mm - The outgoing direction can be rotated by 330.
Application:
- Hydraulic/lubrication
- Pump - Cooling system
- Ventilation system
- water treatment
- Leak detection
Technical Parameters:
1.Measuring range
Water: 1... 150cm/s (the default display value is demarcated in
water and specified in other media)
Oil: 3... 300cm/s
Air: 20... 2000cm/s
2.Measuring medium: water, oil, gas and other compatible stainless steel medium
3.repetitive:1%@<0.6m/s;3%@<1.5m/s;10%@>1.5m/s
4.pressure:100bar(300bar optional)
5.Initialization time:1...8s
6.Response time: Typical value2s
7.power supply voltage:18-30Vdc
8.No load current consumption:≤40mA,24Vdc
9.Switch output (normally open + normally closed)
Output type: PNP/NPN/ relay optional/normally on/normally off can be set
Load capacity: 500mA at 24Vdc power supply (NPN and PNP type)
60W (relay type)
10.Wiring protection: Reverse phase, overload, short circuit protection
11.Display:
Design: 3 red leds (flow rate < switching point)
1 yellow LED (flow rate = switching point)
4 green leds (flow velocity > switching point)
12.Temperature:
Working/storage temperature: -40... 85 ºC
Medium temperature: -20... 85 ºC (- 30... 120 ºC)
13.material
Case: 304 stainless steel
Probe: stainless steel 304/ stainless steel 306L
14.Protection level: IP67
15.Appearance: M12*1 connector
DIEMENSION:
Audited Supplier 
){kind=link}